I completed a diagnostic on a Carrier Multi-Speed 2.5 Ton Electric Furnace / "Slope" Coil. I found there is a window directly under register in question is open and has a window unit in it. I put more insulation around register boot in the attic. This is the only register that’s doing it so I’m thinking it’s just the window drawing in hot air causing the register to sweat.
I completed a diagnostic on an American Standard AC unit. I found the contractor was pitted. The fan was most likely overheating causing compressor to overheat. I gave the customer options and they decided to replace the unit.
I gave an estimate to install a ductless heat pump (mini-split). I included in the estimate is a 1 year free service maintenance agreement.
I completed an installation inspection on an attic.
I completed spring tune up on a Trane air conditioner. I visually inspected the furnace. I inspected the evaporator coil. I checked the temperature difference across the coil. Checked voltage and amps. Inspected heat pump. Checked refrigerant charge, voltages and amps. I rinsed the condenser coils with water. There were different repairs needing to be done, but the customer insisted on doing it himself.
I performed a diagnostic on a Ducane air conditioner. I found that the unit had a leak and was extremely low on refrigerant. I added 5.5 lbs of R-410A. I also found that the dual capacitor was bad and needed replaced but the customer declined the repair.
I completed a scheduled maintenance agreement tune up and safety check on a heat pump.
I completed a scheduled maintenance agreement tune up and safety check on a heat pump.
I completed a scheduled maintenance agreement tune up and safety check on a heat pump.
I completed a scheduled maintenance agreement tune up and safety check on a heat pump.
I performed a diagnostic upon arrival furnace throwing high limit code. I recommended replacing filter every 2 weeks or less depending on how much construction he's doing in the home. System on and heating at departure.
