Chris was very respectful and got everything taken care of quickly.
Explained all of the options clearly and helped me make an informed decision. Got an appointment very quickly.
Great service in replacing my HVAC. They even found a way to save me some money😃
If I ever have an unsatisfactory technician visit, you’ll hear from me for sure.
He is prompt, professional and courteous.
Very thorough estimate appointment-taking time to answer all questions and examine the situation completely
We sincerely appreciated how well Miguel explained everything, he walked us through how to use our system and he double checked that everything was working perfectly. We will call in to have him come every time.
Performed a heat tuneup. Checked heat operations, all components, and safeties. Found dirty blower wheel and weak blower capacitor.
Tested and checked all components -Replaced Air Filter 20x24x1, in hallway Return. -No gas leaks -53 degrees temperature rise -Tightened all low and high voltage wiring -Performed safety inspection on Heat Exchanger; No areas of concern. -Evaporator Coil inspected for restricted air, light dust build up -Indoor Blower motor Amps 5.93 out of 14.5A Max -Run Capacitor 33.92uf out of 35uf+-6% -Cleared Inducer port -Cleaned Ignition assembly; Burners & Flame Sensor -Hot Surface Igniter in good shape, no heat stress. -Primary circuit Board okay at this time -Inducer Assembly amp draw .54A out of .68A Max -Inducer Capacitor 4.90uf out of 5uf+-5% HVAC operational at this time. Recommendations New Water Heater 50Gal $2,050 Active Air Purifier $1,062 Call Complete.
Performed sidekick maintenance on 1 year old Lennox gas/electric split system. Everything is within specs on both sides. System is operational and heating and cooling at this time
Upon arrival I tested heat pump system for operation. System operating normally. Tested system 4 times and each time system ran normally. I found contactor has burn marks and is pitting, defrost board shows signs of burning but still functional, compressor LRA is reading higher then specifications indicating it is working harder then it should. Blower wheel is dirty and reading higher then specification amp draws. System is operational at this time.
Performed sidekick visit. Completed heating and AC inspection and tune up on Lennox heat pump system. Replaced filter today. System is operating properly at this time.
Recommend having repair vs replace consultation due to age/reliability of equipment, operating condition/cost of repairs, efficiency and r22 phaseout.
Remove and properly dispose of old equipment. Install new 3 Ton Variable Capacity Heat Pump split system. Install new 5â€ media filter cabinet at air handler. Replace both disconnect boxes at air handler and at heat pump, also replace electrical whips fuses and install new breakers if needed. Replace foundation pad for heat pump. Seal air gaps underneath platform of air handler in closet. Replace return air filter grill with high flow grill. Remove and properly dispose of old duct system, replace all new R8 ducts with new supply registers. Remove all insulation and perform attic seal, deep bury ducts with R44 insulation. Complete clean up and walk through with journeyman installer. Title 24 HERS testing fees included. Pull and pay for permit fees. Entire job paid in full by service financing Total Job Cost $23,964.65 Total Rebate $3750 paid to client from SMUD in 4-6 weeks Total job after rebates $20,214.65
Upon arrival talked to customer and came to conclusion that extra work will be needed to be done. Customer decided to modify wood work around gas line instead of modifying gas line.
Performed diagnostic on a 2018 Coleman furnace. Upon arrival found system was non operational, plugged pressure switch hoses, unclogged all hoses. Test heater system and has a 13 degrees temperature rise. Adjusted blower speed from high to med, temperature rise improve to 18 degrees. Gas pressure at 12 coming in and 10 out. Found incorrect orrifices size at 54, tech support confirm it should be 55. Suggest replacing propane kit at this point to diagnose further. Give estimate for repair.
Ran new dedicated 220 circuit for possible future EV. Ran new circuit from main panel in back yard to detached garage. Put in new conduit and new breaker. Terminated in cut in box in garage. Brendon is getting a metal 2 gang cover for the box in the garage, he will install it, Mark it and photograph it.
Search for gas leak using bubbles on water heater. Could not detect leak at this time.
Replaced Tstat which was bad from box. Ran and tested operations. Installers to finish flashing.
FaceTime inspection. Inspected system to make sure it is installed correctly and up to code. System is good to go. No corrections needed. Gave customer the packet of inspection paperwork.
Customer request FaceTime inspection service performed FaceTime inspection service inspector states initial inspection is a fail due to no locking caps and carbon monoxide detectors installed carbon monoxide detectors in appropriate areas installed locking caps on condensing unit inspector now state inspection is a pass
Upon arrival customer stated dripping noise coming from inside of wall from upstairs hallway bathroom. Attempted to duplicate dripping noise by running faucet, shower, and flushing toilet. No dripping noise. On the way out dripping noise occurred. Crawled in attic to try to locate possible leak. No evident leak. Opened small square under vanity sink to expose piping. Portion that was exposed didnâ€™t have any evidence of leaks. Customer didnâ€™t want to go with further demolition of wall. He will be opening wall in attempt to find leak and contact Huft to get quotes for possible repairs.