HVAC service inspection conducted in response to customer concern about uneven airflow following recent residing work. Testing revealed significant temperature differentials between rooms, with some vents discharging air at 90°F while others measured at 108°F as confirmed with digital temperature gauge. Unable to fully diagnose root cause due to finished basement and inaccessible ductwork; recommended further investigation to determine if issue related to siding installation or pre-existing condition.
Responded to service call for leaking meter horn. Upon inspection, found leakage from one of the meter connections. Installed customer-supplied meter horn in place of the previous unit. Post-installation inspection confirmed successful repair with no leaks detected.
Arrived at a customer's home to find that the heat pump was not providing adequate heating, with the system repeatedly tripping the breaker. After a thorough inspection, I discovered that the compressor's capacitor had failed, causing an electrical overload. I replaced the faulty capacitor, reset the system, and ensured the heat pump was running smoothly, restoring efficient heating to the home. The customer was thankful for the repair
Electrical panel installation. We carefully connected circuits to provide reliable power distribution throughout the house, verifying each connection for proper function. After a thorough inspection, we confirmed the panel's operation, leaving the homeowner with a safe and efficient electrical system.
Arrived at a residential home to address a leaky pipe under the kitchen sink that was causing water to pool. Upon inspection, we discovered a cracked pipe joint that required immediate replacement to prevent further leakage. After carefully installing a new joint and securely tightening all connection, we resolved the issue.
The customer contacted me because their furnace was blowing cold air, leaving their home uncomfortable. I started by checking the thermostat settings and inspecting the system components, using my multimeter to test the ignition system. I discovered a faulty igniter that was preventing the furnace from igniting properly. After replacing the igniter and ensuring all connections were secure, I ran the furnace through a full heating cycle to confirm it was working correctly. The heating was restored, and the customer was relieved to have warmth back in their home.