~ RUN 145 FT. OF 8/3 ~ INSTALL 40 AMP BREAKER ~ INSTALL ELECTRIFY AMERICA
Install a generator control switch. Job summary mount plywood on left-hand side of panel in garage then mount generator control switch on plywood make 1 inch knockout through side of panel bring line side of wires on to breaker and load side get splice with existing wires once you relieve the existing wires off the breakers. Need a 1 inch whole saw a 1 inch paddle bit.
After diagnostic of master bedroom and office went outside found that breaker was not holding proceeded to reset it and everything’s working as of now.
Troubleshoot power in garage area. Replace dimmer in master bedroom.
Service fee , quote to install new circuit in kitchen from main breaker outside
Adding a circuit breaker to the panel, and wiring the fire alarm system. Running 40 feet of 12-2 wire in 14 feet ceiling, and connect the wire to the outlet.
Install dimmer switch, service fee Service fee
Diagnostic of electric charger what was found last electrician that was here use number eight wire when it should’ve been number six wire use 50 amp breaker when it should’ve been 60 amp breaker
Installing parts chandelier fixture Customer will install the lights and crystals themselves the housing an the mountain of the light fixture and base and the wiring will be done by us.
Repair light switch in master bedroom circuit make contact with ground wire and cause a short
Service fee, install new 50 amp 2 pole gfci breaker and circuit Prewire from existing main breaker panel, hot tub circuit for customer supplied hot tub
Service fee, install new 100 amp sub panel, check out existing power on outside outlets boat house and home , remove existing photo cell from existing flood lights and replace one light in boat house
Service fee, install transformer to existing wiring going to existing wiring intercoms and disconnect existing intercoms so we could install door bell camera