Came out today for a no heat call on a goo System that chud installed in 8/22. Model #GM9C801005CN, serial #2205022463. Upon arrival the system was calling for heat but was not operating. I opened the access panels to look inside. Upon inspection I found that the control board was receiving power and passing power but the led light would not come on. I went to the thermostat and turned the heat off and set the fan for on. The furnace still did nothing. I checked for voltage at the terminals between g and c and received a reading of 24volts. I disconnected the mulex plug from the blower to check the voltage and it was receiving 120volts. As I was looking around I placed my hand on top of the board and found water. There are dried water spots on the back plate that holds the control board as well as the roof of the bottom compartment of the furnace. I checked the burner box, inducer and flue for any signs of water but it was all dry. When it rains the basement does take in some water. It