Customer had an anglestop for a fridge that would not turn on, and a stopper for the master bathroom tub that was broken. I got there and turned the water off so that I could replace the anglestop, then I removed and installed the new drain for the tub. After both of these were done I turned the water back on to the home. I checked the anglestop for leaks and found none so I turned it on and now they have water going to the fridge, so that’s done and working properly. Then I turned water on to the tub to make sure it was not leaking underneath and I found no leaks. I then closed the stopper and put water in the tub again to make sure it would seal and hold the water in. It does and is also working properly at this time. I found no further issues at this time.