Jeremy S. Job Checkin

All wiring is tight and in good condition. I found the blower wheel and evaporator coil dirty. I received permission and cleaned them. The customer signed up for our club membership. I completed a complimentary refrigerant leak search on the system. No leaks found at this time. The refrigerant pressures are in correct range per manufacturer specifications. I completed our check sheet for the system. The system is working properly at this time.

Josh J. Job Checkin

Upon arrival repaired leak in system. Pulled vacuum down to 432 microns. Recharged system with 6lbs 410a. Unit pressures 132/350, 18sh, 11sc. Unit ops are normal at this time.

Jeremy S. Job Checkin

I recovered the refrigerant and removed the old coil and EEV. I replaced the coil, EEV and filter drier. I pressurized the system with nitrogen to 400psi for 15 min. No leaks present. I placed the system under vacuum under 300 microns. I charged the system to manufacturer specifications. The system is working properly at this time.

Josh J. Job Checkin

Jeremy S. Job Checkin

All wiring is tight and in good condition. No refrigerant leaks found at this time. The systems are clean and in good condition. All motor amps are in correct range per manufacturer specifications. I prepared a quote to reroute the attic drain line to the opposite side of the house per request. The refrigerant pressures are in correct range per manufacturer specifications. I completed our check sheet for the system. The systems are working properly at this time. The customer signed up for our club membership.

Trey M. Job Checkin

During my inspection today, the customer greeted me at the front door. They allowed me to come inside and they showed me around to all the equipment. They showed me the air filter(s). It was a 20 x 25. They then showed me the thermostat. It was a Honeywell Nonprogrammable. They then showed me the indoor unit and the outdoor unit. I got started by turning the system off at the thermostat and made my way to the air handler. I inspected multiple different components on the system, including the blower wheel/motor, evaporator coil, drain line, ductwork(dirty, scheduled cleaning), electrical connections/components, etc. I checked all of these components for proper operation and cleanliness. As well as to make sure that nothing was damaged. I made my way to the outdoor unit. On the outdoor unit I inspected multiple different components as well, including electrical connections/components, Condenser fan motor, Compressor, Motor amp draws, Refrigerant pressures(good), And the outdoor unit

Mike M. Job Checkin

Arrived to the customers home and greeted them at the door. Spoke with the customer about how the system has been performing. I’ve had any concerns before starting today’s inspection. Completed maintenance inspection with all cleanings per membership. Completed maintenance inspection, checklist uploaded pictures and videos. With the customer about dryer van cleaning, which was declined for today. Return system to service.

Mark D. Job Checkin

Customer called for annual maintenance. Informed me when I arrived that they didn't want their indoor units done at this time. Checked the outdoor units instead. Checked coils and found them to be clean with no signs of leaks at this time. Checked outdoor capacitors and found them to meet manufacturers set points. Checked outdoor compressors and fan motors amp draws and found them to meet manufacturer set points. Checked pressures with gauges and found them to meet manufacturer set points. Checked compressors with megohmmeter and both are reading bad, too, a video of the reading. Schedule a return trip on April 15 th and informed the customer of the $49 return trip, customer is fine with it and signed the estimate for that pricing.

Trey M. Job Checkin

During my inspection today, the customer greeted me at the front door. They allowed me to come inside and they showed me around all the equipment. They showed me the air filter(s). They were 20 x 20, 14x20. They then showed me the thermostat. It was a Honeywell Nonprogrammable. They then showed me the indoor unit and the outdoor unit. I got started by turning the system off at the thermostat and made my way to the furnace. I inspected multiple different components on the system, including the blower wheel/motor, evaporator coil,drain line(flushed with a gallon of hot water), ductwork(dirty), electrical connections/components, flue pipe, gas pressures, heat exchanger, etc. I checked all of these components for proper operation and cleanliness. As well as to make sure that nothing was damaged. I made my way to the outdoor unit. On the outdoor unit I inspected multiple different components as well, including electrical connections/components, Condenser fan motor, Compressor, Motor am

Mike M. Job Checkin

Arrive to the customers home and greeted them about the door. Spoke with the customer about how the system has been performing and if had any concerns at this time. Customer stated that this was their parents home and are getting it ready to go on the market this year. Completed today’s maintenance inspection. Completed maintenance inspection, checklist uploaded pictures and videos. Customer did decide to go with our basic membership while still owning the property. Collect the payment, collective signatures, and return system to service

Chris B. Job Checkin

Upon arrival inspected indoor unit which was clean free of debri at this time. Leak searched indoor coil no leaks detected at this time. Blower motor clean amping within manufacturer specifications at this time. No surge protector for the indoor unit provided options for customer. Checked drain line no water safety on drain line was clear of debri at this time. Uv light was operating properly at this time customer could notice a difference. Outdoor coil was clean no leaks detected at this time. Electrical connections clean tight and secured no signs of damage capacitor was in the correct range.

Mike M. Job Checkin

Arrived to the customers home and greeted them at the door. Spoke with the customer and how the system has been performing if had any questions or concerns. Completed maintenance inspection today found no issues or concerns with equipment. Completed all cleanings per membership. Also completed maintenance inspection checklist. Uploaded pictures and videos from today’s service. Went over dryer vent wall cap. Concern customer still not interested at this time. Return system to service.

Jeremy S. Job Checkin

All wiring is tight and in good condition. The refrigerant pressures are in correct range per manufacturer specifications for the weather. The filter is ready to be replaced. The system is clean. I cleared and tested the ez trap. I completed our check sheet for the system. The customer declined options at this time.

Mike M. Job Checkin

Arrive to the customers rental house and greeted him outside to receive the lockbox code and combination to gain access into the upper level apartment. Recovered refrigerant from system. Removed filter drier and filled compressor. Installed new compressor with new filter drier pressurize system for leaks and pulled into a deep vacuum. Charged system back to manufacturer specifications and started and started heat pump. System back up. Confirmed all operations were working with manufacturer specifications. Left thermostat at 45* set point per owner. Return system to service locked department and return key to lockbox.

Mike M. Job Checkin

Arrive to the customers rental and greeted him out front. Customer showed me where all equipment was in apartment A, and apartment B. Spoke with the customer about how the systems have been performing and if they had any concerns at this time customer stated that apartment B is empty and up for rent and just looking for a maintenance service Completed today’s maintenance inspection on apartments systems. Completed maintenance inspection checklist uploaded all pictures videos. While customer was on site at the beginning. Found compressor in system. B has come apart at the scroll and would need to be replaced. Explained to the customer. Would be emailing a replacement estimate for the compressor under warranty. Found no other issues with apartment a. Created estimate for apartment B repair. Also quoted for a club membership for customer to receive potential discount on compressor replacement. Return systems to service.