1. Arrived to clients house and preformed initial inspection. Customer called saving his lines froze over. 2 we noticed that the evaporator coil and blower motor were 80-90% covered in dust. We took out the blower motor and cleaned it. Cleaned out the evaporator coil and cleaned the condenser unit. Noticed the start capacitor was reading below the rated uf. We chared the unit with 410A until the hub cooling reached the manufacturers 10 degrees. 3. We cleaned out work area, transitioned to close and thanked customer for their business. This option is the least expensive option that would safely address what we were called out for. * Pull and clean blower assembly * In place evaporator coil cleaning for better air flow * R 410 a refrigerant recharge by super heat and sub cooling