Upon arrival customer states some of his zones aren’t working properly. After checking the system this is what I found, all zone valves read high ohms at 80-130. After locating all stations I put new connections and it stayed the same, the only 2 zones not coming on are zones 4,6. The controller is sending proper power but all zone valves are not receiving the proper voltage. I believe he has several bad valves plus the wiring has been damaged somehow causing the two valves to go out and eventually all of the stations. To complete this job he would need 195ft of 7 strand wire, and 6 same hole valves. He may be interested in a rachio as well.