546 Bryne Drive Unit D
Barrie, ON L4N 9P6
8884410008

Local Reviews
for hamilton, on


Job Locations
for hamilton, on

Ashley O.

Ashley O. Job Checkin

Service Call: Commercial Dock Leveller Issue: Dock leveller is not raising properly Work Performed: Found an issue with the pump, Topped up hydraulic fluid, Tested multiple times for safe and proper operation.

Service Call: Commercial Dock Leveller

Issue: Dock leveller is not raising properly 

Work Performed: Found an issue with the pump,
Topped up hydraulic fluid,
Tested multiple times for safe and proper operation.

Ashley O.

Ashley O. Job Checkin

Service Call: Commercial Overhead Door Issue: Door is stuck half way down Work Performed: Untangled Cables and place back on the drum, Tested door multiple times for safe and proper operation


Ashley O.

Ashley O. Job Checkin

Service Call: Commercial Overhead Door Issue: Roller fell out of track Work Performed: Adjusted both back hangs and added angle to both sides Re-installed roller Lubricated door and tested for safe operation


Ashley O.

Ashley O. Job Checkin

Service Call: Work Performed: Found that the doors with he issue were the entrance to the garage and the door that leads to where the judges park Found there was power to the doors They had been lifted open manually and the j arm was off the inside door The red traffic light was flashing outside I went through all the safeties and they all were responding I reset the ground loop detector up top of the ramp and The doors were then able to be controlled by the remote Verified all safeties for the doors


Ashley O.

Ashley O. Job Checkin

Service Call: Work Performed: Found door to be out of balance Tried slipping the coupler 5 different times Door would go back to its original spot every time Recommend replacing coupler, two key ways and possibly if necessary cutting a bit of the shaft and sliding it over.


Ashley O.

Ashley O. Job Checkin

Service Call Work Performed: Reattached track to back hanging Replace broken bolt Replace damaged top fixture (BRACKET) and roller Also replace 2 other damage 3” rollers Put cable back on drum Test operation all ok