Service Call: Commercial Overhead Door Issue: The cable has come off the drum and the door is inoperable. Work Completed: The technician found the door was hit so he lowered the door and put cables back on, straightened out the bottom section the best he could and cycled the door multiple times for safe and proper operation.
Service Call: Commercial Overhead Door Issue: The door is really hard to open and close Work Completed: The technician replaced 6 rollers, 4 hinges and a slide lock. The technician lubricated all moving components on the door and tested it multiple times for safe and proper operation.
Service Call: Commercial Overhead Door Issue: The door needs some work done as some rollers are broken. Work Completed: The technician replaced hinges, rollers, weather stripping, brackets and lubricated all moving components on the door. The technician cycled the door multiple times for safe and proper operation.
Service Call: Commercial Overhead Door Issue: The rollers keep popping out of the door and it wont slide very well. Work Completed: The technician replaced the chain hoist brackets, replaced the hinges, replace 6 rollers and put on a new set of cables. The technician tightened the track, lubricated all moving components on the door and cycled multiple times for safe and proper operation.
Service Call: Exit Man Door Issue: The door is not opening and closing properly. Work Completed: The technician found the hinge to be bent and replaced it and lubricated all moving components on the door. The technician tested the door multiple times for safe and proper operation.
Service Call: Automatic Entry Door Issue: Front automated door is not engaging, it makes a loud grinding sound and doesn't open. Work Completed: The technician replaced the sensor and a bracket that was causing the noise. The technician lubricated all moving components and tested the door it to ensure safe and proper working condition.
Service Call: Commercial Overhead Door Issue: The door only comes up half way then stops and goes back down. Work Completed: The technician found that the brake solenoid was faulty so he replaced it with a new one, replaced the worn Key way, adjusted the photo eyes and lubricated all moving components on the door. The technician tested the door multiple times for safe and proper operation.
Service Call: Commercial Overhead Door Issue: The lock for the door broke and the weather stripping on the outside is torn bent and needs to be replaced. Work Completed: The technician replaced the slide lock and replaced the weather stripping on the outside of the door. The technician cycled the door multiple times for safe and proper operation.
Service Call: Commercial Overhead Door Issue: The door will not fully close, it stops about 9 inches from the ground and opens back up again. Work Completed:Installed new drive chain, Installed new a new sleeve anchor. Lubricated all components of the door, tested door multiple times for safe and proper operation.
Service Call: Commercial Overhead Door Issue: Door will not close all the way, it stops 2 inches from the ground. Work Performed: Adjusted limits on the operator, lubricated all components of the door. Tested multiple times for safe and proper operation.
Service Call: Commercial Car wash Door Issue: Cash wash door will not open all the way. Work Performed: Replaced 7 Seized Rollers, tested door multiple times for safe and proper operation.
Service Call: Commercial Overhead Door Issue: Door stops before it hits the Ground Work Performed: Adjust limits on Door and braking unit Tested for Safe operation
Service Call: Work performed: Saw cut new 6’x3’ loop and seal Install new gate arm Check operation
Service Call: Work Performed: Replace damaged side lock Check operation
Service Call: Work Performed: Unjam door and secure reset cables Lower door and replace damaged hinges and rollers Repair left side horizontal track Level door and adjust tension Reset limits Operate and test multiple times Check operation
