We had a drain leak in the kitchen sink. It was 60 year old drain pipe connected to new PVC pipe in the basement. The old pipe rusted out. Replacing it meant removing the kitchen cabinets or breaking through the opposing wall. Jim came up with a way to bypass the old pipe with new PVC by going straight down through the cabinet and connecting to the PVC drain pipe in the basement. Saved a lot of money and headache.
Jon did a very thorough job of checking out my system, even though is was past 8pm on a Friday night. Kudos to him and Bell for hiring quality guys.
Tested and certified 1â€ Febco RP backflow for our customers irrigation system. Backflow passed. Bell will submit all required paperwork to the corresponding water purveyor. Paid full amount with a card. Tech: Tomas.
Came out to investigate lift station. Ejector pit is completely filled. Needs to have it pumped so I can gain access to the equipment.
Augered and cleared customers toilet. Tech: Tomas.
Warranty coil freezing being replaced one week from Monday.
Flange only had 2 screws in it and was loose. Put 2 more screws in and put new wax seal. Toilet is now solid to floor.
Kitchen sink drainage water is leaking in a brick wall down to the basement below. 60+ years Durham fittings and inch and a half galvanized pipe exists. Scheduled with Alex to have Brad Garton out Thursday, August 12 between 11 and 12 to provide a proposal to run a new drain line through the bottom of the kitchen cabinet and tie into the existing PVC pipe below and cap the vent above the roofline. Also, provide a separate proposal to remove the existing inch and a half PVC pipe below and replace with 2 inch. When all the new piping is installed, clean out the existing drainage if it remains. Michael, with Colorado Cleanup Services, will contact Wilma and schedule a time to come out to provide a proposal for cleanup and restoration.
Chris Rosales came out due to no cool, upon arrival saw blower motor was very dirty.motor over amping and run capacitor was bad. Customer agreed to repairs, once repair where completed check pressures, unit is low on charge and customer agreed to recharge unit. Customer does not want a leak teak due to Lance coming out on Tuesday of next week for a quote. Unit is now cooling at this time with a 12 degree superheat and 18 degree delta.
Tested and certified 1â€ Wilkins RP backflow assembly. Tech: Tomas.
Client wanted new customer supplied top mount stainless kitchen sink installed and old sink removed. New customer supplied kitchen faucet installed too. Gave options and client authorized work. I removed old sink and found the existing hole in counter is a little bit too small for new sink. Need granite cut to open hole. Client will have granite counter fixed to fit new sink, then have us return to finish work. Collected half of job cost today. Will collect rest upon completion.
Chris Rosales came out due to no cool, upon arrival found set screw has come lose from blower shaft, was able to tighten set screw to blower shaft. Unit is cooling at this time.
Arrived on site for kitchen back up, homeowner stated that disposal was sending water into other basin when ran and then water wouldnâ€™t drain, they also stated that the water went down but they could not recreate the scene. We tested the sink and after about 2 basins full and the sink backed up, after going over options was able to access the secondary line with the 100 machine and sent cable out 75ft. Upon retrieving cable found there to be lots of grease build up and recommend bio clean. Tested line with both basins full and they drained normally, repeated 3 times with no issues. Homeowner is now BVR. Paid with CC No warranty/drain
Tested and certified 1â€ Wilkins RP backflow Assembly. Tech: Tomas.
Tested and certified 1â€ Watts RP backflow assembly. Backflow passed. Bell will submit all the required paperwork to the corresponding water purveyor. $157.00 to be billed. Tech: Tomas Magallan.
Tested and certified 3/4â€ Watts RP backflow assembly. The backflow assembly passed. Bell will submit all the required paperwork to the corresponding water purveyor. Total of $224.00 to be billed. Tech: Tomas Magallan.
Tested and certified Watts 3/4â€ RP backflow. Backflow Assembly Passed. Bell will submit all required paperwork to the corresponding water purveyor. Paid $224.00 with check #7482. Tech: Tomas Magallan.