Thank you for the care that is taken when working on our unit.
Overall Experience
Quality
Price
Convenience
Overall Experience
Quality
Price
Convenience
Overall Experience
Quality
Price
Convenience
Overall Experience
Quality
Price
Convenience
Overall Experience
Quality
Price
Convenience
Overall Experience
Quality
Price
Convenience
Overall Experience
Quality
Price
Convenience
Overall Experience
Quality
Price
Convenience
During inspection I found a primary electrical is comprised, also found flex duct not attached any more Gave cust estimate will return asap to complete rec work
Amana heat pump with air handler installed in 2020. All electrical connections are tight with no corrosion. Ecm blower motor is acceptable. Blower wheel and evaporator coil are clean. Delta T at 19 degrees. Compressor and condenser fan motor are acceptable. Compressor saver has been installed. UV bulb was replaced on this visit. Refrigerant levels are in range.
45 capacitor Saftey float Compressor saver Uv light System is fully functional.
Tech arrived at a service call. Upon inspection the main breaker was tripping. The compressor was disconnected and the fan ran. The compressor was tested and failed the Ohms test and resistance test. The capacitors were out of tolerance. The wire insulation was damaged on the fan motor and was touching bare metal. The contactor was scorched. The indoor system was not accessible today. The customer was informed of recommendations today. Due to age, condition, price of repairs and presence of R22; it is recommended that the customer speak with a Project Manager about upgrading to something more reliable with warranties behind it. The customer will speak with his wife and call in about financing options tomorrow. The tech will follow up at a later time of we haven't heard from them by then. Email is nmkane4676@gmail.com
Ran HTU on heat pump. All heating components tested good. Found biological growth, no attic tent, no hard start and no surge protection. Recommended repairs for all. Customer will talk with wife about installing hard start.
Water heater repairs, replacing both upper and lower thermostats and heating elements with new anode rode install Clear drain with out removing drain lines
Replaced contactor coil relay inside of the airhandler. Coil shorted out main voltage wiring. Unit is now up and running.
On arrival system was running and heating with no issues. The indoor unit had a clean blower and coil and clear drain lines. The outdoor unit passed all electrical testing. I installed a drain treatment strip and when I left the system was running and heating.
STU complete and thorough evaluation. Indoor unit: Customer replaces 1inch filters every 3 months. 2012 4 ton HP r410a. Second stage electric heatstrips OHMs 2ithing tolerance. Electrical wiring tightned. Blower Motor inspected: no biological growth found inside cabin after last level 2 duct cleaning with Microbial spray. Blower wheel clean. Evaporator coil: clean, slight rust and questionable spots, due to age I performed a courtesy leak detection and found leaks. Drain line clear. DeltaT 11.8. Outdoor unit. Coils clean. 50/5 dual run capacitor within tolerance. Condenser fan motor sounds compromised (motor bearings). Harsh compressor sound on startup. Electrical connections tightned. Refrigerant: r410a - indoor has a fixed metering device meaning we consider Superheat. Per data tag on unit from manufacturer, my superheat is higher than specifications. Confirming leak detected in the evaporator coil. I expressed all of my findings to the customer. Customer explained that ab
Amana heat pump with air handler installed in 2020. All electrical connections are tight with no corrosion. Ecm blower motor is acceptable. Blower wheel and evap coil are clean. UV system is installed. Dual run capacitor is within tolerance. Compressor saver has been installed. Compressor and condenser fan motor are working as they should. Refrigerant levels are in range.
Tested all components all measured within ratings and specs. Refrigerant level is normal. Washed and cleaned outdoor unit. Changed filter.
Upon arrival for service system on and cooling poorly. Inspected system. Found refrigerant pressure within proper ranges but off. Cleaned outdoor unit. Refrigerant pressure improved. Found capacitor out of tolerance and causing reduced performance of motors. Replaced capacitor. Refrigerant pressures improved. Left system on and cooling.
Upon arrival for service system on and not cooling. Inspected system and found txv failed closed on system causing restriction on refrigerant line. Recommended speaking with engineer due to age and cost of repairs. Scheduled engineer for Saturday July 22nd 3-5.
Sold LV 1 elec 48k upflow $11,605 pd GoodLeap scheduled 7/11
