08NOV2023 Jason Brown Arrived for blue club two system fall tune up. Spoke with homeowner about the systems performance. We have ran the heater, and everything seems to be working. Cycled main system on into heating at the thermostat. Disconnect power and inspect, heat exchanger and coil. Clean flame sensor, test HSI. Reassemble equipment and test gas pressure and flame sensor. Measure heat rise and CO levels. Check amp draws on inducer and blower. Pull flue and inspect induction wheel. Clean wood debris off equipment and clean out cooling wheel. Verify pressure hoses are clear. Button up equipment and replace the 20x25 filter. Inspect Goodman furnace. Remove blower assembly and inspect coil and heat exchanger. Reinstall blower clean flame sensor test HSI and cycle heat. Set gas pressure and measure heat rise. Inspect heat pump. Verify reversing valve operates. Check electrical connections, cycle defrost. Check contactor and capacitor. Found Goodman coil rusted but clean, found Goodman