Relocate and extend existing 3-phase circuits at hood area to new location for meat cutting machines. Adjust wire size, circuit breaker and conduit / cables to accommodate new machines at 3-phase, 20-amps. Eliminate two (2) existing 3-phase receptacles along with the wiring from the stove area. Reuse the space in the existing panel for the new machines. Covert three (3) existing single phase, 240-volt receptacles to 3-phase, 240-volt, 20-amp receptacles in the same location. Note: Existing panel may not be large enough to handle the additional loads. Kings will not be responsible for overloads. Permits are not included. Me & Phil demoed 2 circuits and identifide Pulled out wires too panel ran 3 phase home runs , identifying circuits.. Installed breakers. And outlets Job is complete