Trane 2.5t variable speed electric air handler with 10KW auxiliary And outside heat pump Install replacement 20x20x1 pleated air filter, test run all equipment in heat pump mode, test run all equipment in emergency heat mode from the thermostat. Confirm 10KW operation, Upstairs return air grills are humming most likely due to restricted or undersized ductwork but otherwise the system is running in good condition considering the age
Two system WaterFurnace 5 series geothermal heating equipment preventive maintenance tune-up, cleaning, filter inspections, safety inspection, run test. Homeowners initial concerns were cold and drafty in the evenings. Both 5 series single stage systems have add-on 10KW electric heat accessory kits however the newer master bedroom addition system has never ran in auxiliary or emergency heat due to the fact that the interconnecting wiring from the air handler to the heat strip package was never completed at the heat strip pack end. Finish low voltage control wiring at the heat strip pack and test run equipment in all heat modes. Confirm 10KWs operation on both systems and neither system had any active or stored service codes outside of the normal hot water generator and system cycle counters Suspect that the master bedroom equipment system has lower than usual ground loop temperatures causing the freezing at the uninsulated joints in the crawl space basement and also lowering the sup
Carrier high efficiency furnace with geothermal heat pump installation
Replacing bad motor module on Waterfurnace 5 Series geothermal unit in Mt. Gilead, OH.
Re-level and support Trane Heat Pump on its pand and intstall pump ups.
Chemical cleaning on Waterfurnace Geothermal unit on Mt. Gilead, OH.
Finishing registars and ductwork and install a/c on new house
Finishing furnace and ductwork for new house
Installing a Trane A/C and Furnace in Mt. Gilead, Ohio
Installing new furnace and duct for new house
Setting a furnace for a new construction custom home in CandleWood Lakes
