Working on a 2005 Mini Cooper. We inspected for needed maintenance. We bled and flushed the brake fluid system and replaced the front struts and strut mounts.
Working on a 2008 Mercedes CLS550. We completed the Mercedes A Service scheduled maintenance and we bled and flushed the brake fluid system.
Working on a 2006 Mercedes S350. We diagnosed an issue with the driver's door lock not working. We replaced the left front door lock actuator assembly.
Working on a 1997 BMW M3. We diagnosed an issue with the check engine light "CEL" coming on and causing a slight noise at idle and we inspected for needed maintenance. We replaced the secondary air injection pump and relay, we replaced the evaporative system canister, we replaced the air mass meter intake boot, and we replaced the main belt tensioner pulley.
Working on a 2007 BMW X3. We diagnosed an issue with the vehicle that was causing it to lose power when driving and the check engine light "CEL" was coming on. We replaced the computer for the engine (DME), we replaced the variable valve timing camshaft adjuster and the eccentric shaft sensor. We also replaced the thermostat housing assembly due to a coolant leak.
Working on a 2006 Mercedes S350. We diagnosed an issue with the power door locks and the trunk soft close feature not working. We replaced the vacuum / pressure supply pump (PSE) for the central locking system and trunk soft close.
Working on a 2007 BMW 328i. We diagnosed an issue with the engine not starting at times after driving. We replaced and programmed the battery and inspected for needed maintenance.
Working on a 2013 Mercedes ML350. We inspected for needed maintenance and completed the Mercedes B3 scheduled maintenance.
Working on a 2006 Mini Cooper S. We completed the Mini W11 engine oil and filter service and inspected for needed maintenance.
Working on a 2008 BMW 328i. We pressure washed the engine to diagnose an engine oil leak and inspected for needed maintenance. We resealed the engine oil filter housing including changing the oil, replaced the upper radiator hose and cooling hose below filter stand due to being deteriorated and swollen from engine oil, replaced the valve cover gasket, replaced the lower oil pan gasket, replaced the engine air filter and replaced one of the daytime running lamp (halo / angel eye).
Working on a 2009 Volvo S40. We replaced the right C.V. drive axle as reported from a previous visit.
Working on a 2008 Mercedes CLS550. We diagnosed an issue with the rear trunk lid not wanting to close, diagnosed an issue with the TPMS (tire pressure monitor system) light flashing, we diagnosed an inoperative driver's door lock, tested the starting and charging system due to the vehicle being slow to crank, inspected the brake system due to a squeal in the morning when backing up, inspected for light bulbs out due to a bulb malfunction light on and inspected for needed maintenance. We replaced the trunk lock actuator, replaced the battery, replaced the rear brake pads and rotors, replaced the camshaft end plugs and the crankcase vent valve, replaced the engine air filter and replaced the left front outer door handle.
Working on a 2009 BMW 335i. We diagnosed an issue with the check engine light "CEL" coming on and causing a rough idle in the morning and inspected for needed maintenance. We completed a N54 engine oil and filter change service, replaced front brake pads with rotors and wear sensor, completed the BMW vehicle check service, replaced the right rear tail light bulb carrier, replaced the power steering reservoir cap seal and replaced the cabin air filter.
We completed a pre-purchase inspection on a 2013 Toyota Camry.
We are working on a 2010 BMW 128i. We diagnosed an issue with a headlight bulb not working and a daytime running light (Halo bulb) not working. We replaced the xenon headlamp control unit and one daytime running light (Halo bulb).