1833 North Cameron Street
Harrisburg, PA 17103
(717) 236-9039

Local Reviews
for east earl, pa


Job Locations
for east earl, pa

Mark B.

Mark B. Job Checkin

Arrived at location on 6/13/22 - Found bottom burner flame sensor was warped and grounded on the burner I did bend the flame sensor back for temporary use. I will obtain a new flame sensor and return. Returned to location on 6/27/22 - Arrived on site and installed replacement flame sensors. Tested unit and have proper functions. Unit ok for use.


Service C.

Service C. Job Checkin

arrived, stated dishwasher is not washing properly. checked unit over, turned on and allowed to run, wash pump is running, all detergent pumps are working properly. found both wash arms were not turning freely, bottom wash arm barely turning at all. removed both wash arms and cleaned build up and reinstall, both are spinning freely now, run cycle with dirty dishes, with one cycle, dishes now appear clean, confirm unit is operating properly now with customer. unit is ok for use. did inform customer on how to address this issue in the future, on how to remove wash arms and clean as needed. ****contacted Mark at champion, this repair will not be covered under warranty.****


Service C.

Service C. Job Checkin

Replaced the Combi Oven heat exchanger and module and sensor and door gasket. I checked ops, OK, ready to use


Service C.

Service C. Job Checkin

Found the Combi Oven moisture level was said to not work all the time, found it is working now. Will need a new controller and overlay to repair. Brian will let us know if he wants the parts replaced.


Service C.

Service C. Job Checkin

Found ALS Combi oven working, oven full of beef. Will return if problem reoccurs. 7-5-18 Removed control, downloaded menu, removed SD card. Replaced with new. Installed control, uploaded software and menu. Tested, cooked for 30 minutes, okay for use. note: did see signs of mice chew, showed Noah.


Service C.

Service C. Job Checkin

Arrived, spoke with customer, statement won't turn on. Found unit displaying time and date and that was it. Removed front board and checked connections. Called factory, spoke with Ian, he had me check voltage from DC power supply, okay, had me remove small board from front board and then unit would turn on. Picto board is shorted. Will obtain new and return. 1-23-18 Removed failed board, replaced with new, tested okay for use.


Service C.

Service C. Job Checkin

Arrived met with Steve. Stated oven won't heat after they had in cleaning mode. Removed covers found fuses blown on relay board. Figured out it was the cleaning pump that shorted out. Unhooked pump. OK for use as long as they don't clean. will obtain pump and return. 3-9-2017 Arrived removed side cover. Removed power from unit. Removed old pump. Installed new. Checked found leak. Removed pump again. Re-secured clamp. Install pump.Tested OK.


Service C.

Service C. Job Checkin

Checked and found error 3 fan failure. Found 6 flashing on VFD. Over current detected. Switch VFD with top unit. Issue went away. Customer would like new VFD ordered over night. Item was in stock, no QWP (expedited freight) charge 12-23-2016 Removed old VFD. Installed new. Tested. OK for use. *Left bad part behind for customer. They may try and repair for themselves.


Service C.

Service C. Job Checkin

Found hose reel leaking. Found hi limit tripped in generator. Found cleaning pump shorted. Found water flow meter faulty. Will obtain parts Replaced all parts that were ordered. Checked for leaks. Found none. Replaced pump and sensors. Tested. OK for use. **Travel and miles are billed to WO #120860


Service C.

Service C. Job Checkin

Found hose reel leaking. Found hi limit tripped in generator. Found cleaning pump shorted. Found water flow meter faulty. Will obtain parts Replaced all parts that were ordered. Checked for leaks. Found none. Replaced pump and sensors. Tested. OK for use. *Travel and miles are billed to WO #120860


Service C.

Service C. Job Checkin

Checked Combi oven and found E4 error on display. Removed site cover and found more wires chewed. Ribbon cable to relay board has bare wire. Also saw the mouse. Spoke with Brian. Was able to repair more wires for oven to work. Customer will when the mouse is obtained. -- Removed cover. Replaced communication ribbon cable. Checked connections. All secure. OK for use.