1833 North Cameron Street
Harrisburg, PA 17103
(717) 236-9039

Local Reviews
for robesonia, pa


Job Locations
for robesonia, pa

Mark B.

Mark B. Job Checkin

Arrived at location on 1/7/23 - On arrival found that unit was running warm. What gauge is up and found that compressor was not running. Checked start and run cap they were good. Put a 3in 1 on and found that compressor was bad. I took the 3n1 out. You will need a new compressor cap tube and filter drier for unit to work properly.


Mark B.

Mark B. Job Checkin

Arrived at location on 3/15/22 - Found door switch not closing. Adjusted the door switch. When the door shuts and stirrers squeaking found inner cavity stirrers open cover and plastic pieces dirty and falling apart. I did clean the cover and rails but they do need replaced. I will obtain parts and return. Returned to location on 3/25/22 - Replaced the stirrer antennas and motors. I replaced the door springs and ceiling plates. I checked ops. Ok ready to use.


Service C.

Service C. Job Checkin

while doing pm found walk in freezer at 15 degrees. checked power had 210 going to unit, checked coil on contactor had 210 to it but not latching in contactor. went and picked up new contactor and returned re moved old contactor and replaced with new contactor replaced two terminal ends and powered unit on, contactor latched in and compressor running checked freezer temp dropped down to temp and cycling properly all okay.


Service C.

Service C. Job Checkin

Walk-In Cooler Unit was at temperature when I arrived, Checked thermostat and evaporator and were good, Checked condenser unit and found some bubbles in site glass, Checked refrigerant level on receiver and found to be slightly low and also found king valve seat to be leaking on receiver, I tightened seat on king valve and added 11 ounces of R22 to system, unit is down to set temperature at this time and cycling properly


Service C.

Service C. Job Checkin

Took measurements to replace Walk-In Cooler gasket. Details as follows; 37 1/2 x 77 1/2 hinge right Hartford curacool wic, profile 516 inside lip. Will order gasket and return. Customer also stated they want a price on re-sealing ceiling. This was the result of mold and moisture over the summer. Noted that insulation in walls and ceiling are breaking down. We can attempt to reseal seams but this is not a guaranteed fix. Price to re-seal is $750.00. 12/19/18 Replaced and formed the door gasket. Replaced the door closure. Door closes properly now


Service C.

Service C. Job Checkin

Arrived, checked into location. removed old gasket and cleaned track. on Convection Oven, installed new gasket.


Service C.

Service C. Job Checkin

Arrived, found right conveyor skips and gets jammed easily. Motor seems like it it's weak. Will obtain new motor and rear bearing for shaft. Unit is okay for use at this time on left side. 4/20/18 Did replace the drive motor for the right belt. Checked ops, okay, ready to use.