Overall Experience
Quality
Price
Convenience
Diagnosed and repaired persistent low water pressure issues throughout two-story home. Found partially closed main shutoff valve and sediment-clogged aerators at multiple fixtures. Biggest issue was discovered in basement—corroded galvanized pipe with approximately 80% blockage from mineral buildup. Replaced affected section with copper and added two access points for future maintenance. Installed whole-house sediment filter at main line to prevent future buildup. Water pressure now testing at consistent 63 PSI throughout home.
Finished replacing 40-gallon electric water heater with new hybrid heat pump model. Upgraded drain pan and installed expansion tank to meet current code requirements. Reconfigured water lines with PEX for better efficiency. Added temperature and pressure relief valve discharge tube directed to proper drain location. Programmed unit for maximum energy savings during typical usage hours. Left owner instructions for maintenance schedule and operation modes.
Completed bathroom drain line repair where previous owner had used improper S-trap configuration, causing frequent clogs and sewer gas odors. Reconfigured to proper P-trap with appropriate venting. Discovered additional issue with insufficient slope in horizontal run. Corrected pitch to standard 1/4" per foot for proper drainage. Used camera inspection to verify complete drain line integrity after repair.
Replaced leaking pressure reducing valve on main water line today. Found inlet pressure at 110 PSI, dangerously high for residential plumbing. New valve set to maintain 65 PSI throughout home. Added pressure gauge for monitoring. Tested all fixtures after installation—no leaks and proper flow restored to all faucets.
Installed outdoor lighting system for residential backyard. Used low-voltage LED fixtures to minimize energy consumption while maximizing brightness. Buried cable 6 inches deep in protective conduit under walkways. Programmed timer to activate lights at sunset. Added photocell override for cloudy days. Positioned uplights to highlight trees and accent lighting along garden path. System draws only 85 watts total at full operation.
Completed kitchen remodel electrical work including new island outlets, under-cabinet lighting, and dedicated circuits for refrigerator, dishwasher, and microwave. Added GFCI protection to all countertop receptacles per code requirements. Installed dimmable recessed lighting with LED fixtures. Connected smart switches for voice control compatibility. Updated panel directory with new circuit labels. All work passed inspection first attempt with compliments from inspector on wire management.
Finished troubleshooting intermittent power issues in detached garage workshop. Discovered rodent damage to underground feeder cable approximately 18 inches below grade. Replaced damaged section with waterproof direct burial cable and added metal conduit protection. Installed junction boxes at transition points for future serviceability. Added GFCI protection to all garage outlets and verified proper grounding. Recommended quarterly visual inspection of exposed wiring to customer due to continued rodent activity in area.
Completed electrical safety inspection for residential customer who purchased 1950s home. Found ungrounded outlets throughout, aluminum wiring to several circuits, overloaded panel with double-tapped breakers, and missing junction box covers in attic. Provided detailed report with prioritized recommendations for corrections. Installed smoke/CO detectors as immediate safety measure. Scheduled follow-up appointment for most critical repairs. Advised customer to budget for complete panel replacement within next 12 months based on visible corrosion and lack of expansion space.
Completed panel upgrade from 100-amp to 200-amp service today. Replaced outdated fuse box with modern circuit breaker panel. Installed new grounding system and updated service entrance cable. Coordinated with utility company for meter replacement. Job passed inspection with no corrections required.
Finished installation of backup generator system for residential customer with medical equipment needs. Installed 14kW natural gas generator with automatic transfer switch. Connected essential circuits including refrigeration, heating, bedroom outlets, and medical equipment power. Added surge protection for sensitive electronics. Programmed weekly self-test routine during daytime hours. Provided customer training on manual operation procedures and maintenance requirements. System successfully tested through multiple simulated outages with transfer time under 15 seconds. Left comprehensive documentation package with warranty information and maintenance schedule.
Electrician replacing broken light switch.
Electrician, replacing drivers and recessed lighting
