When I arrived I found that the indoor air movement system was not working. After troubleshooting I found that the board was supplying the correct voltage. I spoke with the client about his different options and he chose the Hc13d. I replaced the air movement system, cleaned the air circulation system, installed a new voltage protection system, redid wire terminals, reset and set up the comfort control system properly, tested in heating and cooling. I was to cool inside and outside to check pressures. When I was testing the heat I found that the temperature rise was too much and shut the furnace down. I then made some adjustments on the dip switches on the furnace board and got the temperature rise to an acceptable amount. The system is now operating properly at this time.