Upon arrival in Dale I performed HC18C. I removed the 2 disconnects and placed them in the correct spot to replace the faulted ones. I then ran new 6 gauge wire to the air handler from the disconnects. Performed a chemical cleaning on the heat transfer media coil. Once I stated on replacing the blower wheel and cage I found the motor to be very sieved and not coming off with the blower wheel puller I had. Another technician arrived on site with a different puller and we were able to get motor removed from the wheel. I then installed the motor onto the new blower wheel and cage. After reinstalling back into the system I tested the system and found that everything is operating properly at this time.