Reviewed project and measurements. Another company was out to service unit and water heater was replaced. Djv was the company. Connections left open, water heater is not level.
Reviewed information with Karen to provide estimtate for replacement of ac unit for second floor. Karen would also like pricing kfor repairing unit, as it needs a board and blower motor according to other company servicing unit.
Reviewed equipment to provide estimate for replacement.
Reviewed jobsite and measured equipment for replacement. Prepared proppsal for replacement.
Good Afternoon to The First State! As you may have guessed, I am working in Delaware right now. I am finishing up a Tune Up on a Smith Gas Fired Boiler. After undoing two screws and disconnecting the Gas Pipe, the whole Burner Assembly slides in/out as one piece (as seen from the video). Once this is pulled out you have access to the burners, as well as the pilot light Assembly. With this out, I was also able to look up into the Heat Exchanger to inspect it.
Good Afternoon to The First State! As you may have guessed, I am working in Delaware right now. I am finishing up a Tune Up on a Smith Gas Fired Boiler. After undoing two screws and disconnecting the Gas Pipe, the whole Burner Assembly slides in/out as one piece (as seen from the video). Once this is pulled out you have access to the burners, as well as the pilot light Assembly. With this out, I was also able to look up into the Heat Exchanger to inspect it.
Good Afternoon to The First State! As you may have guessed, I am working in Delaware right now. I am finishing up a Tune Up on a Smith Gas Fired Boiler. After undoing two screws and disconnecting the Gas Pipe, the whole Burner Assembly slides in/out as one piece (as seen from the video). Once this is pulled out you have access to the burners, as well as the pilot light Assembly. With this out, I was also able to look up into the Heat Exchanger to inspect it.
Good Afternoon to The First State! As you may have guessed, I am working in Delaware right now. I am finishing up a Tune Up on a Smith Gas Fired Boiler. After undoing two screws and disconnecting the Gas Pipe, the whole Burner Assembly slides in/out as one piece (as seen from the video). Once this is pulled out you have access to the burners, as well as the pilot light Assembly. With this out, I was also able to look up into the Heat Exchanger to inspect it.
