Pride Plumbing was called out for no water from a well. Our inspection found that ants had gotten inside the pump’s pressure switch in between its contact points. We de-energized the pump, removed the dead ants, cleaned the contact points with a wire brush, turned the power back on, and the pump began to work. We also provided a cost estimate perform the following work: 1) pull the well's submersible pump and black roll piping; 2) install a new submersible pump, black roll piping, and wiring (with an attached torque arrestor and cable guards) and reinsert them down into the well; 3) replace the well's 30/50 pump switch, pressure gauge, nipple, and pressure tank and charge the tank; and 4) reseal the well using a heat shrink kit.