Pride Plumbing was called out for sewage backing up into the home. We used a water pressure device at a cleanout underneath the home and cleared a blockage in the main outside sewer septic drain line. We also provided a cost estimate to replace the kitchen sink's under-sink drain assembly, P-trap, and drain line through the floor to under the house in the crawlspace, and to where it ties into the main sewer drain stack, with new PVC piping and fittings.
Pride Plumbing came out and provided a cost estimate to install a new Pride Plumbing supplied Insinkerator Badger 5 garbage disposal along with replacing the kitchen sink's PVC waste piping and P-trap.
Pride Plumbing came out and repaired a leaking toilet's ABS drain line underneath the home. We cut out the leaking ABS Santee and wye and replaced them with new PVC piping and fittings; connecting them onto the existing piping with new Fernco and no-hub couplings.
Pride Plumbing was called out for a water leak underneath the home. We found a leak on an ABS drain line. We provided a cost estimate to cut out the leaking section of pipe and repair it with new PVC piping and fittings.
Pride Plumbing was called out to investigate the cause of a higher than usual water bill. However, by the time we arrived, the customer had found and corrected the issue.
Pride Plumbing was called out for a water leak underneath the home. We found a leak on a PEX water supply line. We cut out the leaking section of pipe and repaired it with new PEX piping and fittings. We also provided a cost estimate to repipe and replace the water supply lines under the house in the crawlspace, going to the fixtures in the kitchen, washing machine, and one bathroom, with new PEX piping and fittings.
Pride Plumbing came out and provided a cost estimate to install a yard hydrant in the yard (this would require us to dig a trench from the water meter to the hydrant’s location; install the new yard hydrant and PEX piping going to it; connect the PEX piping to the existing outside main water supply line - adding a ball water shutoff valve; pour pea gravel around the new yard hydrant; cover the pea gravel with new cement; and cover and tamp the new water line’s trench).
Pride Plumbing came out and provided a cost estimate to install a yard hydrant in the yard (this would require us to dig a trench from the water meter to the hydrant’s location, install the new yard hydrant and PEX piping going to it; connect the PEX piping to the existing outside main water supply line, pour pea gravel around the new yard hydrant, cover the pea gravel with new cement, and cover and tamp the new water line’s trench).
Pride Plumbing came out and replaced a leaking bathtub/shower faucet valve with a new Delta R10000-UNBX rough-in valve, added a Delta T13420 chrome trim kit (replacing the shower head, valve cover and handle, overflow cover, and downspout push button diverter) and converted the valve's copper above-floor hot and cold water supply lines to PEX piping and fittings; tying them into the home's existing copper main water lines.
Pride Plumbing came out and collected a water test due to an egg smell in the water and hard-water buildup on the faucets.
Pride Plumbing was called out for a leak on a Maytag washing machine's drain line. Our inspection found that the drain's glued fittings were separating. We replaced the washing machine's P-trap, drain and drain line through the floor to under the house in the crawlspace, to where it ties into the main sewer drain stack, with new PVC piping and fittings. We tested the drain line for leaks and the issue was corrected.
Pride Plumbing was called out for a water leak at a Maytag washing machine. We replaced the hot and cold water boiler drains with new quarter turn valves as well as short sections of the piping coming up through the floor with new PEX piping and fittings.
Pride Plumbing was called out for issues with a septic tank. Our inspection determined that the septic tank was full and the sewage pump wasn't working. We provided cost estimates to perform the following work: 1) pump the septic tank; 2) install 24-inch diameter septic tank risers up to two-feet deep (septic tank risers are installed so that the tank's access covers are at ground level for better access); 3) pull and clean the sewage ejection pump and replace its float switch and check valve; and 4) replace the sewage ejection pump along with replacing its check valve, ball valve, and union.
Pride Plumbing was called out for a clogged Project Source toilet. When we arrived, we found that the stoppage had already cleared itself. We provided a price quote to replace the toilet with a new Gerber Viper model. This would include inspecting/cleaning/replacing the flange, replacing the toilet bowl, toilet tank, tank to bowl gasket and bolts, seat, wax ring gasket, toilet bowl bolts, toilet bowl bolt washers, toilet bowl bolt caps, and above-floor stainless steel braided water supply line.
Pride Plumbing came out and replaced a 40-gallon electric Rheem hot water heater with a new 40-gallon electric Rheem PROE40-M2-RH95 650265 model. This included removing and disposing of the old water heater; and installing the new water heater, new ball water shut-off valves, new PEX and stainless steel water supply lines to the water heater connectors, a new brass drain valve, wiring up the electrical connections, ensuring that the unit was properly vented, and setting it to its appropriate operating temperature. We also provided a price quote to repipe and replace the water supply lines under the house in the crawlspace, going to the fixtures in the kitchen, one bathroom (sink, toilet, and bathtub/shower), the washing machine (installing a new plastic washer box and hot and cold hose bibs or boiler drains), and the water heater, with new PEX piping and fittings (installing new 1/4 turn ball water shut-off valves on each fixture inside the house along with new above-floor stainless st
