View visual findings from this job here - https://visionshare.xoi.io/?id=XA-A243-C9285BDB71C7486A8E32B8165115A326 Customer has no heat from K2 high-efficiency boiler: * At arrival, the boiler is displaying an error code for ignition failure * Open up the boiler cabinet * Found heavy corrosion on most components and small water leak from inside the boiler * The wire for the flame sensor is completely corroded * Remove both the flame sensor and igniter- both components are dirty and in need of cleaning * Cleaned both components with copper bristle brush, and paused with steel wool * Reinstalled both components and tested system operations * After reinstalling the components, the boiler is still failing to fire * Spoke with the manufacturer and found multiple issues with the system * One of the issues is a orange wire that is connected to the ground for the flame sensor- This orange wire splits And I was instructed to remove the spade connector As it has been discontinued from this b