Pride Plumbing came out and provided a cost estimate to replace a non-working E/One sewage pump. This would require us to: 1) call in our septic pump truck and pump out an existing sewer tank; 2) dig up and remove the old E/One sewer pump, tank and control panel; 3) excavate the tank hole and the area around it in order to install a new pump tank and place gravel in the hole; 4) set the new E/One sewer pump into the tank; 5) make the proper drain line and vent connections; 6) install the ball and check valves on the discharge and vent lines respectively; 7) run electrical wiring out of the top of the lid for the electrician to wire the pump into its control panel; and 8) after the unit is properly wired, test it for proper operation.