Overall Experience
Quality
Price
Convenience
Mark did thorough cleanup on all the heating units. He also provided options with good explanation (not just push for replacement) on thermocoupler.
Overall Experience
Quality
Price
Convenience
Gary went above and beyond to service the air handler units and change filters. He even helped me to grab some debris from the crawl space that I can’t get into.
Overall Experience
Quality
Price
Convenience
Water Panel 1 Gas Hot Water Boiler: New Yorker and x3 Air handler units with Hydro coils. x1 Carrier Furnace not being used as a Furnace to heat the home. Perform a tune-up and cleaning to help ensure reliable and safe operation. Inspect for cracks & deterioration of Heat Exchanger Check and clean Burners an heat exchanger- ok, vacuumed-ok Check and clean flame sensor and ignition Assembly-ok Check porcelain for crack or carbon buildup. Check igniter electrode gap. Check Safety Controls-ok Check electrical wiring and components-ok Check Gas valve & Gas Line-ok Check Combustion Air & Exhaust-ok Check Temperatures & Water pressure settings; Check Low water cut off, water feeder and expansion tank. Performance-ok Check and run Thermostats- operating well at this time. Inspect Argo panel Check zoning operation-isolate and run zoning. Check circulator pumps-ok amps and voltage check. Check flow at supply and return. Check for water leak no leakage at this time. Run and monitored for good
Performed AC maintenance on x3 Hydro Conventional system Chemically clean evaporator coil Chemically treat pans with slow release tabs and gel treatment Flush condensate pans and drain lines Replace Aprilaire #213 filter high efficiency filter. x1 Pristine filter for 1st floor unit & x1 (20x20x1) basement crawl space Visually inspected ductwork for leakage and breaks Clean return grill on second floor Inspect thermostat operation Inspect blower motor and housing for dirt and debris Inspect and test safety switches Inspect and test condensate pump Inspect and test electrical connections Tighten and secure low voltage controls and connections Check temperature split @ equipment Wipe down and polish cabinets Chemically clean condenser coil Check Freon pressure and temperature Inspect and test capacitor/ check for swelling or pitting Inspect and test contactor/ check for burn out or pitting Inspect and test compressor amperage Inspect and test system voltage Clean indoor electrical cabinet
Customer had just recently moved into the home and is having issues with the ductwork and humidifier in the crawlspace sweating and dripping water. The floor joist of the home is spray foamed and the vents to the exterior are opened. Customer is going to need the insulation project manager for an assessment. I reviewed all equipment in the home customer has two central a/c systems located in the basement mechanical room. Both trane furnaces from 2005 the system for the kitchen/ living area is a very old R-22 system. Both units are is rough shape blower wheels are dirty and also a maintenance and duct cleaning is needed. Hot water heater is also 10 years old and is near end of life. Customer is aware of theses issues and will make a decision accordingly. Office to follow up to schedule insulation consultation. https://visionshare.xoi.io/?id=ms18913aee-575d-i184-c9f243618251-uF83-72d1e6d8d76b
Replacement of Attic Spacepak Air Handler and Lennox Condensing Unit
Heating maintenance on gas boiler and (2) hydro air handlers
Insulate Garage Ceiling, Dense Pack with Cellulose
