Homeowner states that he replaced the kitchen sink but also wanted to replace the angle stops with shark bite angle stops but the copper pipe on the hot side was bent and didn’t have the proper tools to press or solder and called us out. Greeted homeowner at door and he showed me the kitchen sink and under the cabinets where the angle stops are located. I suggested replacing both angle stops as well as the tubular pipe and the two basket strainers. Homeowner agreed and I began with the two angle stops by shutting off the water meter and cut off both angle stops. Had to cut the drywall on the hot side due to limited access and homeowner was informed and he agreed to cut the drywall. Installed apex A adapter on the copper and used per pipe to add the shark bite shut off customer supplied as well as the cold side but on copper pipe. Then I proceeded to remove both basket strainers and clean the surface and underneath and installed new basket strainers. Then I removed the p trap and insta