During this visit I checked the functions on the 6 rtu’s that provide cooling for both the office and the warehouse. The all motors on the units were checked for amp draws and their bearings were confirmed to be good. The drains were cleared and the coils were cleaned. Today the outside temp was low however each unit was confirmed to be transferring heat through the refrigerant circuit. These units are in like new condition and have been installed less than a year. No deficiencies were discovered that require further action. While on-site today a few cable ties were added to the wiring harness to prevent the factory wiring from rubbing against the cabinet and a T-stat wire had fallen off of the terminal strip in an rtu which was corrected today. The filters were replaced and all units were within the factory specifications for cooling mode. Thank you, Jon Tech notes: 40#