5558 Berkshire Valley Road STE 6
Oak Ridge, NJ 07438
(973) 838-3200

Our Top Cities


Local Reviews
for nutley, nj


Job Locations
for nutley, nj

Jack B.

Jack B. Job Checkin

Arrived onsite for maintenance of trouble furnace unit. System stopped working. This time it had a code for pressure switch open. Touched the switch and the system started. Performed combustion test immediately due to dancing flame. Found over 700ppm of CO. Pulled analyzer out of flue to protector sensor. Turned system off. Cleaned pressure switch and attached hoses. Measured pressure at from inducer at .72. Fired system up and performed another combustion test. Measured over 800 ppm of CO before removing probe to protector sensor. Measured gas valve outlet pressure at 3.79wc. Rushed to 3.5wc as per label. Removed and Checked flue for a clog. Did not see any. Could not see vent at the top of house for any blockages. Cleaned flame sensor.

Arrived onsite for maintenance of trouble furnace unit. System stopped working. This time it had a code for pressure switch open. Touched the switch and the system started. Performed combustion test immediately due to dancing flame. Found over 700ppm of CO. Pulled analyzer out of flue to protector sensor. Turned system off. Cleaned pressure switch and attached hoses. Measured pressure at from inducer at .72. Fired system up and performed another combustion test. Measured over 800 ppm of CO before removing probe to protector sensor. Measured gas valve outlet pressure at 3.79wc. Rushed to 3.5wc as per label. Removed and Checked flue for a clog. Did not see any. Could not see vent at the top of house for any blockages. Cleaned flame sensor.

Jack B.

Jack B. Job Checkin

Arrived onsite for no heat call. System was switched off upon arrival. Turned system on and system fired up. Then failed after 2 minutes. No error codes. Reset the system, placed probes on the system. The system restarted and didn’t fail again. Measure 56 degree temperature rise which is in range but high. Observed a bit of a dancing flame. Inspected flame safety system and did not observe issue. Duct work is not correct. There is no return box and no supply plenum. Most likely the system is struggling to overcome issue with the ductwork. Next step is to perform a heating maintenance with combustion analyzer. Then see about pricing out a ductwork repair.

Arrived onsite for no heat call. System was switched off upon arrival. Turned system on and system fired up. Then failed after 2 minutes. No error codes. Reset the system, placed probes on the system. The system restarted and didn’t fail again. Measure 56 degree temperature rise which is in range but high. Observed a bit of a dancing flame. Inspected flame safety system and did not observe issue. Duct work is not correct. There is no return box and no supply plenum. Most likely the system is struggling to overcome issue with the ductwork. Next step is to perform a heating maintenance with combustion analyzer. Then see about pricing out a ductwork repair.

Jack B.

Jack B. Job Checkin

If you are experiencing recurring thermostat issues, it may be time to upgrade to a polarized filter. Climate Plus LLC recently completed maintenance and filter installation for a customer with similar concerns. Contact us for reliable service and Any time arrival convenience.


Gianna M.

Gianna M. Job Checkin

Same-day polarized filter installation. The thermostat was checked to ensure it works correctly with wifi. If the filter doesn't solve the issue, we can assist with ordering another Ecobee.


Gianna M.

Gianna M. Job Checkin

Afternoon arrival forl EPP 1C-Maintenance service. Polarized filter was installed the same day to improve the unit's temperature control. The customer was pleased with the ac service.