Customer had a thermostat in. His office and one in the next room. He was using the wrong thermostat. System up and running job complete
Replaced filters and checked operation of one packaged truck. Unit running as it should.
Found burner tripped by flame control. Reset and burner fired up and stayed running. Turned off and back on several times to see if flame would fail again. Watched unit run for a while. Could not find any problems at this time. Need to check with Ron to see if units not having outside air filters can cause problems.
this is a estimate to replace ignition controller. Parts are 1-2 days out and available for install upon arrival. If you would like to have this done please accept the estimate and we will get this scheduled. Thanks Ron. Installed new ignition transformer. Tested unit. Unit firing and running as it should.
Customer didn’t realize they had an open estimate to repair warehouse Mua. Customer said he signed it while we were here.
System needs new spark ignition transformer. Sent over estimate awaiting approval
this is a estimate to install water separator to waste oil furnace and install a vent cap. If you would like to have this done please accept the estimate and we will get this scheduled. Thanks Ron Installed airline filter
Found not getting fuel out of gun assembly. Might need to replace nozzle. Will talk to Ron to verify. System up and running had to temporarily install an air compressor to unit. Sending over estimate for water separator and wind cap
Found thermostat on mobile mini had no batteries and was set for gas heat. Put customer supplied batteries in and switched to electric heat. Cycled up and down below set point. Unit is working.
Need to send Nate building engineeered air units he is very good with them. Pausing to move over to nate. Upon arrival found units shut off at thermostat box. They said it was blowing cold air. Turned on and checked mua’s. Both firing good turned up supply air stats. All ok at this time.
Checked Bard wall mount unit. Electric heat and ac only. Both heat strips kicking on blower ramping up and down. Brought space up to set point and satisfied. All seems to be working as it should.
Leak does not seem to be coming from unit need to get a roofer out here to check for leak in the roof. Unit is 16 years old would recommend replacing as oppose to repairing
PM complete, furnace is operating. Filters have been changed!
Filters was completely plugged causing unit to go out on high pressure. Sent over estimate for pm work awaiting approval