Arrived for a/c tune-up and check out: Created a call for cooling at the thermostat. Inspected furnace condition and operation. Furnace and blower motor were clean and operating normal. Checked return air filter, return air filter was dirty, replaced filter with one off my truck. Checked condensate drain line and cleared drain line out. Checked temp drop across . Had a 19° temp drop across evaporator coil. Checked outside condenser and cleaned coils. Checked amp draw for fan motor and compressor. Both were running and operating normal within manufacturer specifications. Compressor was starting to run slightly high, but still within specifications. Recommended adding a hard start to improve efficiency and help lower amp draw. Checked capacitor, capacitor tested good. Checked contactor condition, had no pitting or rust. Checked wiring, wiring was in good condition. Checked refrigerant charge, manufacturer recommends a 10° subcool plus or minus 3°. System had a 8.8° subcool. Sy
Arrived for a/c tune-up and check out: Created a call for cooling at the thermostat. Inspected furnace condition and operation. Furnace and blower motor were clean and operating normal. Checked return air filter, return air filter was dirty, replaced filter with one off my truck. Checked condensate drain line and cleared drain line out. Checked temp drop across . Had a 19° temp drop across evaporator coil. Checked outside condenser and cleaned coils. Checked amp draw for fan motor and compressor. Both were running and operating normal within manufacturer specifications. Compressor was starting to run slightly high, but still within specifications. Recommended adding a hard start to improve efficiency and help lower amp draw. Checked capacitor, capacitor tested good. Checked contactor condition, had no pitting or rust. Checked wiring, wiring was in good condition. Checked refrigerant charge, manufacturer recommends a 10° subcool plus or minus 3°. System had a 8.8° subcool. Sy
Arrived for a/c tune-up and check out: Created a call for cooling at the thermostat. Inspected furnace condition and operation. Furnace and blower motor were clean and operating normal. Checked return air filter, return air filter was dirty, replaced filter with one off my truck. Checked condensate drain line and cleared drain line out. Checked temp drop across . Had a 19° temp drop across evaporator coil. Checked outside condenser and cleaned coils. Checked amp draw for fan motor and compressor. Both were running and operating normal within manufacturer specifications. Compressor was starting to run slightly high, but still within specifications. Recommended adding a hard start to improve efficiency and help lower amp draw. Checked capacitor, capacitor tested good. Checked contactor condition, had no pitting or rust. Checked wiring, wiring was in good condition. Checked refrigerant charge, manufacturer recommends a 10° subcool plus or minus 3°. System had a 8.8° subcool. Sy
Arrived for a/c tune-up and check out: Created a call for cooling at the thermostat. Inspected furnace condition and operation. Furnace and blower motor were clean and operating normal. Checked return air filter, return air filter was dirty, replaced filter with one off my truck. Checked condensate drain line and cleared drain line out. Checked temp drop across . Had a 19° temp drop across evaporator coil. Checked outside condenser and cleaned coils. Checked amp draw for fan motor and compressor. Both were running and operating normal within manufacturer specifications. Compressor was starting to run slightly high, but still within specifications. Recommended adding a hard start to improve efficiency and help lower amp draw. Checked capacitor, capacitor tested good. Checked contactor condition, had no pitting or rust. Checked wiring, wiring was in good condition. Checked refrigerant charge, manufacturer recommends a 10° subcool plus or minus 3°. System had a 8.8° subcool. Sy