Today November 19 we’ve arrived to install power for the rooftop ventilation fans. From electric panel, we ran 3/4 EMT pipe up the wall into the ceiling space of the warehouse and across the wall to the area where I drilled through the wall into the sales area, where a junction box was mounted. From the junction box we installed 1/2 inch rigid pipe across the wall and up onto the rooftop of the Sherwin-Williams. Installed Unistrut in three different locations on the rigid pipe run to hold it tightly in place so it would not move on the rooftop. We installed a double gang weatherproof box and weatherproof cover. We also installed a rubber boot over the pipe and slid it down onto the rooftop for proper ceiling. Marco who is running the ventilation pipes for Clean Vapor is going to seal it properly. I talked to him about that and he said that he would he would seal it. Last we pulled two sets of black, red, blue #12 thhn and one green #12 wire from the electrical panel all the way to the