Came in quick and got the job done. No complaints what so ever. Highly recommend.
Overall Experience
Quality
Price
Convenience
Overall Experience
Quality
Price
Convenience
Overall Experience
Quality
Price
Convenience
The thermostat was saying low battery on nest thermostat and the o terminal would not energize. Removed wires and stripped wires to make sure connections were good and also rebooted thermostat. The thermostat still wouldn’t work properly. The customer is getting his own thermostat and installing it .
Added correct parts to furnace. Replaced gas valve,orffices,high limit and added sediment trap. Tested work and everything is working properly.
Install new 2.5ton 60k btu gas package unit for back of home Install new outdoor pad Build new dog house Reconnect existing supply and return duct work Install new thermostat System start up
Customer called us out for a clogged toilet in the main floor half bathroom. I tested the toilet and it backed up immediately. Running the sink did not cause the water level in the toilet to change. I recommended either clearing the toilet with a closet auger or replacing the builders grade toilet with a newer one. Customer choose to clear the toilet. I ran a closet auger down the toilet and successfully cleared it. I then tested the toilet multiple times with toilet paper.
Trane Package Unit - Back half of home System nit heating due to a failed inducer motor. The blades on the inducer rusted and sheared off. There is a decent amount of rust inside the system and on the lower cells of the heat exchanger. The heat exchanger is compromised and the blower motor is seeping oil. The system is 13 years old and at the tail end of its life expectancy. I went over repairs and a few options to address the present issue. The homeowner requested we send out our install supervisor tomorrow afternoon to go over updating this system. Thank you for choosing T.E. Certified, have a great day!
We came out today due to circuit #24 which is on a AFCI breaker tripping. The customer stated that the breaker would not stay on even when everything was unplugged. The circuit controls the two bedrooms, the left bedroom has (5) receptacles, (1) single pole switch for a ceiling fan and right bedroom has (5) receptacles and (1) single pole switch for a over head light. These two rooms have a 12g NM-B cable feeding the rooms and is on a 20 amp breaker. We started with a diagnostic and only found one area in the left bedroom where the insulation on the black and white wire where damaged and exposing the copper conductor. We turned the breaker on and turned the lights on with no tripping. I made the homeowner aware that due to the breaker on and holding it is very difficult to find the issue. For a piece of mind we replaced the breaker, corrected the damaged wire. I went into the crawl space to see if any wires were damaged or to see if any illegal wire had been done. The only thing that I
