Responded to no heat call for 15-year-old trailer furnace blowing lukewarm air. Inspection revealed faulty roof jack requiring replacement. Submitted parts requisition form and photographed gas valve assembly and blower components for documentation. Customer will receive estimate for approval before proceeding with specialized repair.
Responded to no heat service call for a 15-year-old furnace. Diagnosed system with green light flashing and blowing cold air. Inspection revealed a cracked ignitor requiring replacement. Performed carbon monoxide safety testing with UEi meter, confirming zero CO emissions after repair. Customer advised about ductwork issues under mobile home, which they will address separately.
Replaced existing thermostat with Ecobee unit per service order. Performed comprehensive wiring inspection, completed necessary cleanup of connections at furnace, and properly connected all system components including refrigerant monitor, air cycler, and condenser. Successfully configured Wi-Fi connectivity and assisted homeowner with mobile app setup to ensure full system functionality.
Installed replacement thermostat per service order #193077-001, completing wiring connections and proper mounting of new unit. Existing wires (R, C, G, Y, W, O/B) were properly terminated to the corresponding terminals on the new thermostat base. Service required follow-up visits to complete installation.
Responded to warranty callback for HVAC system installed within the past year. Customer reported deteriorated exterior seal around line set penetration, which was confirmed upon inspection with visible damage to the insulation and potential entry points for moisture or pests. Successfully resealed the line set penetration with a generous application of silicone to ensure complete closure and prevent future water intrusion or pest access.
Completed 2-hour repair of HVAC system by installing new inducer motor, secured parts from WC Johnstone. Additionally installed outdoor air temperature sensor (OAT) to ensure proper system operation. Verification photo shows properly installed inducer motor with acceptance tag, confirming successful completion of the repair as sold by Roger.
Responded to no heat call for a 5-6 year old system with blinking light indicating combustion air switch failure. Diagnosed bad inducer motor as the primary cause of heating failure. Replaced inducer motor and installed new air filter to restore proper system operation.
Performed water treatment system assessment for customer whose current water softener was failing and leaking (currently bypassed). Inspection of utility area revealed exposed plumbing infrastructure with existing water filtration components. Evaluated installation requirements considering current PVC piping configuration and meter setup in partially finished utility space. Provided comprehensive estimate for new water treatment system replacement.
Performed annual furnace tune-up on unit of undetermined age. Replaced dirty air filter with customer-provided new one, cleaned flame sensor, and advised customer on proper air exchanger maintenance. Identified humidifier pad requiring replacement and provided homeowner with replacement options. Recommended regular filter changes every 30-90 days.
Fixed electrical meter clips that were bent and the meter wasn’t holding correctly. Was able to re-bend and align the clips as it looks like someone or something hit the meter and caused the bent clips as they were bent all the same direction.
This system is now operating properly. The gas line leak has been repaired and tested. Manager is going to reach out to center point and have gas turned back on.