Inspected 89-gallon tanked water heater exhibiting severe damage with hole burned through the side near heating element. Found melted, discolored wiring and compromised metal shell with extensive rust staining on lower front panel. Determined unit requires complete replacement due to safety hazards and structural failure.
Responded to no-heat complaint on recently installed furnace experiencing short cycling. Diagnosed issue as severely clogged filter caused by homeowner's use of ultrasonic humidifier with tap water. Replaced filter, provided spare, and educated customer on proper humidifier operation requiring distilled water to prevent future blockages.
Responded to service call regarding water leakage around water treatment system comprising three vertical tanks (two black filtration units and one green nitrate filter). Upon inspection, identified a crack in the drain adapter on the nitrate filter as the source of the leak. Replaced the damaged adapter with a new component from inventory, resolving the water leakage issue.
Resolved fluctuating water pressure issue by replacing faulty pressure tank. System inspection revealed pressure switch was operating properly but tank had failed. Additionally, capped off unused PVC waterlines and an abandoned cast iron pipe from previous toilet installation per customer's request.
Performed comprehensive furnace tune-up on residential unit. Inspected filter (noted as getting dirty), verified clean and balanced blower, and checked all electrical components finding them within specifications. Identified water damage in upper and lower cabinets from condensate backflow through intake. Unit operation tested at maximum heating rate for 15 minutes with 70°F temperature rise (within 60-90°F specification range). Recommended installation of in-line drain to prevent further condensate damage; customer requested estimate.
Performed inspection of residential water supply system and found first valve leaking at the seam. Provided homeowner with estimate options for valve replacement, including replacement of 3/4" copper supply line valve before water meter.
Completed gas pressure validation and adjustment following LP regulator replacement by gas company. Verified proper operation of newly installed secondary regulator and confirmed appropriate gas pressure settings for both high and low fire operation using dual port manometer.
The customer had been experiencing issues with their AC unit, and I was called in to diagnose the problem. After inspecting the unit, I discovered that the compressor had failed. I replaced the compressor and performed a thorough cleaning of the system to ensure that it was working properly. The customer was thankful for the service.
Inspected hot metal smell coming from a Lennox Furnace in Allen.
Install new well pressure tank T and valves for Joyce R. In Strum Wi. The old fittings were really corroded and leaking ba.
Repair a furnace motor in Strum WI that just wouldn't turn anymore. Time for a new furnace, these things don't last forever.
