Responded to a service call regarding disconnected ductwork causing exhaust to enter the building. Upon inspection, discovered significant soot buildup in the ventilation pipe requiring cleaning. Reconnected the ductwork properly and addressed the improper combustion issue that was causing excessive soot formation in the exhaust system.
Responded to service call for temperature fluctuations in Rhyme Time Classroom. Thermostat was set to 70°F but temperature was swinging between 66-70°F with no heat output. Diagnosed faulty thermostat and replaced unit to restore proper system operation.
Responded to short cycling complaint on 2008 Goodman furnace. Performed basic cleaning and diagnostic testing with combustion analyzer, confirming proper operation with 95.9% efficiency. System is now running consistently without premature shutdown issues.
Responded to no-heat call for 2019 LuxAir gas furnace. Performed basic cleaning and check, including removal of dust accumulation from blower assembly and heat exchanger. System was restored to proper operation, bringing indoor temperature back to thermostat setpoint after previously maintaining 8° below desired temperature.
Performed warranty service replacing Goodman LP furnace with new unit. Reused existing LP kit and stainless burners during installation. Completed installation in basement with proper venting and ductwork connections.
Responded to customer complaint of heating system failure (thermostat set to 71°F with actual temperature at 61°F). Diagnosed issue with flame ignition despite pilot light being on. Performed maintenance on flame sensor and cleaned sensor ports which were showing significant corrosion and rust buildup as documented in photos. System successfully restored to normal operation with proper heating function verified before departure.
Responded to customer complaint of water leakage from furnace. Inspection of Lennox unit revealed exhaust pipe connection was not properly glued, causing exhaust gases to leak onto furnace. Repaired by properly applying adhesive to the PVC joint and verified proper system operation after repair.
Responded to no heat call and diagnosed high limit switch tripping due to severely clogged filter. Replaced standard 16x25x1 air filter, cleaned system, and verified proper operation through multiple heating cycles to ensure normal function was restored.
Replaced defective pop top zone valve on Kenmore boiler system. Installation completed successfully with customer-supplied parts. System functioning normally with proper circulation through the newly installed zone valve.
Replaced heat exchanger under warranty in customer's HVAC furnace. Performed complete disassembly of unit to access and remove failed exchanger, then installed new OEM component and reassembled furnace with all electrical connections properly restored. Tagged unit and documented repair with supporting photographs of internal components.
Remove water heater and installed customer provided water heater added two three-quarter inch couplings, use pre-existing cold press copper customer requested and one 2 inch coupling seven PVC tested for gas and water leak all is good. customer will call the office in the morning for payment.
Installed new sill cock on left front of house that froze and burst due to weather. Comes with two years parts and labor warranty.
Customer and I decided to remove garbage disposal and doing so we decided to install sink strainer P-trap and adapt to one T and used one bottle of clover to thin out grease tested filling up both sinks several times with hot water. All is clear. and then went in master bath bedroom cleaned out hair from stopper. I then adjusted stopper so customer will be able to pull it out and pull her own hair out when needed tested all is good.
Augered men’s toilet and couldn’t get thru. Pulled toilet to find a toy in trap and couldn’t not remove. Nikki said she would get new toilet and install.