The customer had a fixture under the kitchen cabinet, above the kitchen sink that needed to be replaced. This is what was completed today: Verify circuit for the fixture of the kitchen sink and it is properly labeled in the panel Check the switch and wiring that controls the light- Found quick wiring to be terminated on the switch, we applied hooks to the wiring and attached them to the screws. Remove the existing fluorescent fixture that is mounted underneath the sink and install a new customer supplied LED type Remove pin that got stuck in puck light fixture on the right side of the sink. I informed the customer that the socket has signs of over heating. In the panel I found that the Ultra Surge Protector is installed on a 20 amp 240v breaker. I informed the homeowner that manufacturers recommend 50 amps to ensure the surge works at peak performance We supplied and installed a new 2p50 amp GE type breaker for the surge