Installed 3/4 EMT conduit from panel L3A which is located back left/center of the building by the roll up door over to a red beam for a new location sub-panel. We installed a sub-panel on uni strut that is attached to the beam we also have a conduit leaving the sub-panel going over to the small cubical office. We wired in and installed (2) 20 amp circuits for the following: (1) switch and (1) general purpose receptacle (1) A/C outlet. We installed a #6 THHN feeder to power the sub-panel and installed a 2p60amp breaker. After installation we tested for power and the circuits.